Orion 2007-8899999, Instruction Manual

Page: 9 / 26

9
MACHINE OPERATION
POWER SWITCH
Located on the panel door or side of the panel box, the
lockable power switch has two settings:
ON - connects a power source to the machine
OFF - disconnects the power source.
START AND EMERGENCY STOP SWITCHES
The START switch is used to start the cycle once the load
is on the turntable. The cycle may be stopped at anytime
by pressing the STOP button. (see
Figure 1 )
Figure 1
NOTICE:
The STOP button interrupts the entire machine
electrical circuits. To continue the cycle the STOP
push/pull button should be pulled out and START button
pressed for the machine to restart. Double pressing the
push – pull STOP button will reset the machine program
and machine will be ready to apply the wrapping cycle
from the beginning.
SETTING-UP MACHINE PARAMETERS
Note: Parameter change is available when machine is
not in cycle.
1- TOP WRAPS 1,2,3...9
Press button #1 on the keypad to select “Top Wrap”, then
using the arrows on the keyboard select between 1 to 9
for required number of wraps on top of the load.
2- BOTTOM WRAPS 1,2,3...9
Press button #2 on the keypad to select “Bottom Wrap”,
then using the arrows on the keyboard select between 1 to
9 for required number of wraps at the bottom of the load.
Note: Refer to the list of options at the bottom of the panel
sticker for reference.
(
see Figure 3
)
Figure 2
3- REINFORCED WRAPS
This application allows you to apply extra wrap around the
load (overlap) to reinforce and stabilize the load on the pallet.
When ever you feel like adding extra wrap, simply press the
#3 button and the carriage will stop moving. Machine is
preset to apply 1 extra lap around the load, but you can
increase that up to 9, by using the arrow.
Figure 2
4- AUTOHEIGHT EYE
Press button #4 on the keypad to switch from ON to OFF,
or vice-versa.(see
Figure 2 )
ON - When ON, the photocell is activated to automatically
detect top of the load. The carriage will automatically stop
at the top of the load regardless of its height.
OFF - When OFF, the photocell is inoperative and
carriage will travel to the top limit switch regardless of its
height.
NOTE: For proper machine operation, top limit switch
position should be adjusted to desired level prior to
starting the cycle.