Orion 2007-8899999, Instruction Manual

Page: 12 / 26

12
PROXIMITY SENSOR ADJUSTMENT
Occasionally the Feed Back Proximity Sensor may need
some adjustment. The position of the feed back proximity
sensor against the cam is shown on drawing # 419139
and on
Figure 6 .
Adjustment instructions:
¾
Power down machine.
¾
Remove the carriage cover.
¾
Unbolt the two nuts holding the proximity switch - item # 1.
¾
Turn the Proximity sensor - (item # 2) to create the gap
between the cam and the front side of proximity sensor
about 1/8 “.
¾
Tighten on the nuts securing the Proximity Sensor.
¾
Put the cover back on.
¾
Power up machine.
¾
Turning the trim pot SPAN adjust the moment when
motor starts to turn when dancer roller moved from its
home position up to 1 1/2”.
¾
If not satisfied repeat the procedure.
Figure 6