IGS-9168GP User’s Manual
ORing Industrial Networking Corp
37
will stop trying and the configured IP settings will be used.
IP Address
Assigns the IP address of the network in use. If DHCP client function is
enabled, you do not need to assign the IP address. The network DHCP
server will assign an IP address to the switch and it will be displayed in
this column. The default IP is
192.168.10.1
.
IP Mask
Assigns the subnet mask of the IP address. If DHCP client function is
enabled, you do not need to assign the subnet mask.
IP Router
Assigns the network gateway for the switch. The default gateway is
192.168.10.254
.
VLAN ID
Provides the managed VLAN ID. The allowed range is 1 through 4095.
DNS Server
Enter the IP address of the DNS server in dotted decimal notation.
Save
Click to save changes
Reset
Click to undo any changes made locally and revert to previously saved
values
5.1.5 IPv6 Settings
IPv6 is the next-generation IP that uses a 128-bit address standard. It is developed to
supplement, and eventually replace the IPv4 protocol. You can configure IPv6 information of
the switch on the following page.
Label
Description
Auto
Configuration
Check to enable IPv6 auto-configuration. If the system cannot obtain the
stateless address in time, the configured IPv6 settings will be used. The
router may delay responding to a router solicitation for a few seconds;
therefore, the total time needed to complete auto-configuration may be
much longer.
Address
Specify an IPv6 address for the switch. IPv6 address consists of 128 bits
represented as eight groups of four hexadecimal digits with a colon
separating each field (:). For example, in 'fe80::215:c5ff:fe03:4dc7', the
symbol '::' is a special syntax that can be used as a shorthand way of
representing multiple 16-bit groups of contiguous zeros; but it can
