GB
- 6 -
0000-GB ANBAU (353)
ATTACHMENT
Attachment
• Safety advice: see Supplement A1, points 1 - 8.
• Check that cutter screws and processor tines
are firmly seated.
• Against unsteady, unstable machine after-run:
- Secure lower hydraulic link (U) so that implement
cannot swing out sideways.
Attaching the machine
- Starting position:
Park machine on the support stand (7) on level
ground with bolts (8) inserted and spring pin (10)
secured.
- Attach lower link to the pipe bottom (9) and lock at this
height:
The attaching height corresponds to the parking
height on firm ground.
Fold support wheel (7) up: Pos. O
- Pin jack stand (7) up using bolts (8) and secure with
spring pin (10).
7
9
O
U
TD24/95/3
10
Initial connection to tractor
Electrical equipment: see Supplement
Check driving motor speed (at the tractor)
1000 rpm
= standard driving motor
speed
The pivoting gear (SG) has been factory set for
operation with this rpm (delivery condition).
540 rpm
When only this driving motor speed (540 rpm) is
possible on the tractor, the gear (SG) must be
removed and installed again in reverse.
• Ensure the drawbar is well supported (e. g. with a solid wooden
block "H")!
• Pemove oil filler neck.
• Then install protective cap again.
• For further details see chapter "REVERSING THE GEAR" in the
supplement.
Drive shaft
Use correct drive shaft
• Type W 2500 for a drive motor speed of 540 rpm
• Type W 2400 for a drive motor speed of 1000 rpm
TD8/95/6a
1000 rpm
540 rpm
SG
S
H
TD24/95/47
W 2400
1000 rpm
W 2500
540 rpm
TD 47/96/9
62-00-14