(341) SICHERHEIT 9400 GB
SUPPLEMENT - A
Recommendations for work safety
All points refering to safety in this manual are indicated
by this sign.
1.) Defined use
a. See "Technical Data".
b. The keeping of operating, service and maintenance
requirements layed down by the manufacturer also come
under the heading of "defined use".
2.) Spare parts
a. The
original components and accessories
have been
designed especially for these machines and appliances.
b. We want to make it quite clear that components and
accesories that have not been supplied by us have not
been tested by us.
c. The installation and/or use of such products can, therefore,
negatively change or influence the construction
characteristics of the appliance. We are not liable for
damages caused by the use of components and
accessories that have not been supplied by us.
d. Alterations and the use of auxiliary parts that are not
permitted by the manufacturer render all liability invalid.
3.) Protection devices
All protection devices must remain on the machine and be
maintained in proper condition. Punctual replacement of
worn and damaged covers is essential.
4.) Before starting work
a. Before commencing work, the operator must be aware of
all operating devices and functions. The learning of these
is too late after having already commenced operation!
b. The vehicle is to be tested for traffic and operating safety
before each operation.
5.) Asbestos
- Certain sub-supplied components of the
vehicle may contain asbestos due to
technical reasons. Observe the warning
on spare parts.
6.) Transport of persons prohibited
a. The transport of persons on the machine is not permitted.
b. The machine may only be driven on public roads when in
the position stipulated for road transport.
7.) Driving ability with auxiliary equipment
a. The towing vehicle is to be sufficiently equiped with
weights at the front or at the rear in order to guarantee the
steering and braking capacity (a minimum of 20% of the
vehicle’s tare weight on the front axle).
b. The driving ability is influenced by ground conditions and
by the auxiliary equipment. The driving must be adapted
to the corresponding terrain and ground conditions.
c. When driving through curves with a connected appliance,
observe the radius and swinging mass of the appliance.
d. When travelling in a curve with attached or semimounted
implements, take into account the working range and
swing mass of the implement!
8.) General
a. Before attaching implement to three-point linkage, move
system lever into a position whereby unintentional raising
or lowering is ruled out!
b. Danger of injury exists when coupling implement to tractor!
c. Danger of injury through crushing and cutting exists in the
three-point linkage area!
d. Do not stand between tractor and implement when using
three-point linkage external operation!
e. Attach and detach drive shaft only when motor has stopped.
f. When transporting with raised implement, secure operating
lever against lowering!
g. Before leaving tractor, lower attached implement to the
ground and remove ignition key!
h. Nobody is to stand between tractor and implement without
tractor being secured against rolling using parking brake
and/or wheel chocks!
i. For all maintenance, service and modification work, turn
driving motor off and remove universal drive.
9.) Cleaning the machine
Do not use high-pressure washers for the cleaning of
bearing- and hydraulic parts.
20%
Kg
- A 1 -
Recommendations for work safety