Remedy:
Pull the feeder roller bracket knob away from the feed roller to reduce the
pressure.
Cause 8:
Paper cutting is not at right angle.
Remedy:
Change the angle of the gauge with the help of gauge setting knob fitted on
the gauge itself
Cause 9:
Paper is not pulled by the free wheel roller from its center of the width
Remedy:
Adjust the gauge so that the papers are pulled from the center of its width
Cause 10:
Freewheel roller is not aligned with the gap setting roller
Remedy:
Align the freewheel roll
Fault: Paper feeding paper is double and irregular
Cause1:
Gap between freewheel roller and gap setting roller is too wide
Remedy:
Adjust the gap
Cause 2:
Feed tray inclination is too high
Remedy:
Decrease the feed tray inclination
Cause 3:
Ratchet and Paul mechanism is worn out
Remedy:
Replace the freewheel assembly (
not the feeder assembly
)
Frequently Asked Questions
Under what condition is manual operation suitable?
Manual operation is useful under following conditions
-
paper is jammed
-
settings are to be adjusted
Why is the hinged table adjustment provided for feed tray?
Papers vary in size, weight and smoothness. Art papers and coated papers tend
to slide into the feed roller. This can be avoided by keeping the tray inclination low.
Rough papers should slide themselves down into the feed roller, hence tray
inclination should be higher. The hinged table adjustment allows these settings.
How many papers can I feed at a time? Is it required to stop the machine
when one stack is exhausted?
21
Summary of Contents for OCM 20
Page 12: ...12...
