Feeding Setting Procedure
1.
Take a sample of paper and fold it the way you want to be Creasing,
Perforation, Half cutting. Open it and determine which edge of the paper is to
be feed to the machine. For more information please Figure No. 8.
2.
Fold the paper along its width to find the vertical center line. Mark this line
with a pen or pencil
3.
Place the paper on the feed tray such that feed roller touches the center line
marked by you.
4.
Adjust the feed gauges along the sides of paper. Make sure that there is slight
margin between one of the feed gauges and the paper flow.
5.
Insert a paper in the gap between freewheel roller and gap setting roller run the
machine at very slow speed. Hold the paper at its rear end.
6.
Try to pull the paper back. If the gap is less, the paper will be tired. If the gap is
more you will be able to pull the paper very easily. If the gap setting is
optimum, you will feel slight resistance while pulling the paper back. This is the
correct setting for that particular type of paper. Use fine and coarse gap setting
to adjust the gap. You can master this procedure by practice.
7.
Take the stack of paper to be fed. Fan out the papers & keep the stack on the
feed tray.
8.
Turn the Roller manually. Ensure that one paper is being fed at a time. Adjust
the pressure on feed roller if required.
9.
If papers are pulled over the gauges, they may be squeezed. Adjust position of
the gauges using the knobs.
13
Summary of Contents for OCM 20
Page 12: ...12...
