3. Installation
Installation conditions
Install the motor and capacitor in a location that meets the following conditions.
Using the motor and capacitor in a location that does not satisfy these conditions could damage it.
3.1 Installing the motor
Installation varies with the shape of the motor's output shaft.
1) Round shaft motor
Drill holes in the mounting plate and fasten the motor to the mounting plate with
screws, nuts, and washers. (The mounting screws are not provided.) Be sure that
no gaps are left between the motor and the surface of the mounting plate.
Note: Do not insert the motor into the mounting hole
at an angle or force it in, as this may scratch
the flange pilot section and damage the motor.
2) Pinion shaft motor
Drill holes in the mounting plate and fasten the gearhead (sold separately)
and the motor to the mounting plate using the four screws provided with the
gearhead. Install the equipment so that no gaps are left between the motor
flange surface and the gearhead pilot section end surface.
Refer to the gearhead operation manual for further details concerning
mounting.
(gearhed sold separately )
Note: Use the gearhead of the same type of pinion shaft as the motor.
3) Motor with a cooling fan
When installing a motor with a cooling fan onto a device, leave 10 mm or more behind the fan cover or open a ventilation hole so that
the cooling inlet on the back of the motor cover is not blocked .
3.2 Installing capacitors
Before installing the provided capacitor, check that the capacitor’s capacitance matches that stated on the motor
’
s name plate.
Use the screws specified below to install capacitor. (Screws not provided.)
Notes: 1 When installing the rectangular capacitor with the plastic foot, tighten the screw to
a torque of 1
･
Nm (10 kgcm) or less to prevent damage to the mounting foot.
2
Install capacitor at least 10 cm away from the motor. If it is located closer, the life of
the capacitor will be shortened.
- Indoors (this product is designed and manufactured to be installed within another device)
- Ambient temperature: -10
℃
to +40
℃(
14
to
104 )
(avoid freezing)
- Not exposed to explosive, flammable, or corrosive gases
- Ambient humidity: 85% max. (avoid condensation)
- Not exposed to direct sunlight
- Not exposed to dust
- Not exposed to water or oil
- In a location with good heat ventilation
- Not exposed to continuous vibration or excessive impact
- 1,000 meters or less above sea level
Motor
Mounting Screws
(not provided)
Mounting
Plate
Mounting Screws
First number in motor
name
3
4
5
Screw size
M5
M5
M6
Tightening torque
2.5N
･
m(25
㎏㎝
)
2.5N
･
m(25
㎏㎝
)
3.0N
･
m(30
㎏㎝
)
Motor
Gearhead
Screws provided
with gearhead
Mounting
Plate
φ
4.3
Mounting feet equipped.
Use screws of 4mm in diameter to install the capacitor.
2
(.169DIA.)
˚F
˚F
