4
Parameter ID lists
This part describes the parameter ID lists to be set via EtherNet/IP.
Data and parameters described here can also be set using the
MEXE02
software.
Table of contents
1 Timing for parameter to update ......... 66
2 Maintenance commands ...................... 67
3 Monitor commands ............................... 68
4 Operation data R/W commands ......... 74
4-1 Base address of each operation data
number ............................................................... 74
4-2 Parameter ID ..................................................... 76
4-3 Setting example .............................................. 77
commands .............................................. 78
5-1 Base address of operation I/O event ........ 78
5-2 Parameter ID for operation I/O event
R/W command ................................................. 78
6 Protect release commands .................. 79
7 Extended operation data setting
R/W command ........................................ 80
8 Parameter R/W commands .................. 81
8-1 Driver action simulation setting
parameter .......................................................... 81
8-2 Base setting parameter................................. 81
8-3 Coordinate parameters ................................. 82
8-4 Operation parameters ................................... 82
8-5 Direct data operation parameters ............ 82
8-6 ABZO sensor setting parameters .............. 83
8-7 Mechanism settings parameters ............... 83
8-8 Initial coordinate generation &
wrap coordinate parameters ...................... 83
information setting parameters ................ 84
8-10 Alarm setting parameters ............................ 85
8-11 Information setting parameters ................ 85
8-12 I/O parameters ................................................. 87
8-13 Direct I/O setting parameters ..................... 90
8-14 Remote I/O setting parameters ................. 90
8-15 Virtual input parameters .............................. 91
8-16 User output setting parameters ................ 92
8-17 Driver mode setting parameters ............... 92
8-18 EtherNet/IP communication setting
parameters ........................................................ 92
9 I/O signals assignment list ................... 94
9-1 Input signals ..................................................... 94
9-2 Output signals ................................................. 95
Summary of Contents for A Step AZ Series
Page 14: ...1 Introduction 14 ...
Page 64: ...3 Implicit communication 64 ...