Orient KFA (TD), Instruction Manual

Page: 10 / 135

10
ENGLISH

MODELS WITH SCREWED-DOWN CROWN
Some models have a screwed-down crown that can be locked.
For these models, perform the following procedures before setting.
(1) Before time setting and calendar setting, turn the crown counterclockwise
and loosen.
(2) After time setting and calendar setting are completed, turn the crown
clockwise and tighten.

MODELS WITH A SCREWED-DOWN BUTTON RING
Some models may have a configuration that allows the button ring (ring on the
outer periphery) to be locked (fixed) into place by being screwed down.
Use the following operating method for this type of watch.
(1) When wanting to use the buttons, first turn the button ring to the left, and
then loosen it until the screw stops.
* The buttons may not be able to be used if the button ring cannot be
loosened enough. Do not turn it more forcefully than necessary.
(2) After finishing using the buttons, turn the button ring to the right, and firmly
tighten it until the screw stops.
* Do not tighten it more forcefully than necessary.

SETTING THE TIME AND ADJUSTING THE STOPWATCH
HAND POSITION (Hands for time display, alarm sub-dial, and
stopwatch hands)
This watch allows you to both set the time (basic watch and alarm sub-dial)
and set the stopwatch hands to the “0” position with the crown at the second
click position. Once the crown is pulled out to the second click, check the
following three items, and if necessary, make adjustments, and then push
the crown back in.
(1) Time of the basic watch
(2) Time of the alarm sub-dial
(3) “0” position of the 2 stopwatch hands