Orenco Systems
®
• 800-348-9843 • +1 541-459-4449 • www.orenco.com
NIM-EPS-1
Rev. 6 © 10/21
Page 3
Biotube ProPak and LOS Pump Package Installation Manual
Before You Begin, cont.
Check Package Components!
Be sure that all of the components are included in the pump package before beginning the installation.
Each Orenco pump package comes with a Biotube pump vault, Biotube effluent filter cartridge, effluent pump, discharge assembly, float
switch assembly, splice box, and control panel. Be sure you have the necessary risers, lids, lid screws, riser-to-tank adapters, adhesives,
waterproof wire nuts, and other components required to complete the installation. All of these can be found in Orenco’s Product Catalog,
which is available from your local distributor, from Orenco, and online at www.orenco.com/products.
Note:
All pipe diameters given are US nominal IPS pipe sizes. If you’re using metric pipe, you may need adapters to connect to
the US fittings supplied.
Standard On-Lot Components
1
2
10
10
10
9
9
9
3
6
8
8
7
7
6
4
5
2
1
3
4
5
8
External splice box
7
Discharge assembly (HV-style shown)
9
Access riser
10
Access lid
Control panel not shown
1
Interceptor tank inlet tee
2
Interceptor tank (two-compartment shown)
3
Biotube pump vault
4
Biotube effluent filter cartridge
5
Effluent pump
6
Float switch assembly
Components
Top view (two-compartment concrete tank and HV-style discharge assembly shown; see engineering drawings for project-specific configurations)
Side view (two-compartment concrete tank and HV-style discharge assembly shown; see engineering drawings for project-specific configurations)
