EN
18
Phone beeps
The battery may need to be recharged.
•
Put the handset into the charging cradle of
the base unit. It may take up to 15 hours to
fully recharge the battery.
•
Your handset may temporarily lose its
synchronization with the base unit due to
radio interference in your area. When this
happens, “OUT OF SERVICE” shows on the
handset display.
•
If you do not wish to hear the beep tone,
you can turn it off. See the KEY TONE
section for more information.
Low battery warning
If you just recharged the batteries, but keep
getting a low battery warning, the batteries may
need to be replaced.
•
Rechargeable batteries gradually lose their
ability to store a charge the older they get.
Simply replace the battery with a new one.
MULTI-HANDSET USE
Cannot register new handset
Sometimes it helps to unplug and then reconnect
your base unit to its AC power source before you
start the registration procedure.
•
You may have already registered 4
handsets to the base unit.
•
If you are replacing a faulty handset, make
sure you have fully removed the faulty one
before registering the new one.
•
If you are still experiencing problems, you
will need to reset all the registrations then
start over.
Cannot dial out
Only one outside call and one intercom call can
take place at the same time. Make sure no one
else is already using the phone; if so, you will see
the EXT IN USE
symbol on the handset display
area.
All handsets show “OUT OF SERVICE” and
telephone will not work
Reset your telephone, and then try the registra-
tion process again.
•
If you are still experiencing problems, reset
and then re-register all your handsets one-
by-one.
CALLER ID
No Caller ID display
You must subscribe for Caller ID services through
your telephone network provider for the Caller ID
to display on this telephone.
•
If the caller’s number does not exactly
match what you have entered in your phone
book, including the STD code and any
prefixes, the phone book cannot match the
name to the Caller ID. Check the phone
book to make sure the full number is stored
there in the correct sequence.
•
Is the battery fully charged? If not, try
recharging or replacing the battery.
•
Make sure the base unit is connected to a
non-switched AC outlet.
•
Disconnect the base unit from the plug and
plug it in again.
Caller ID error message
The phone displays this message if it detects
anything other than valid Caller ID information
during the silent period after the first ring.
•
This message indicates either the presence
of noise on the line, or that an invalid
message has been sent from the telephone
company.
REMOTE SENSOR
Cannot find remote sensor
Check the sensor batteries, channel number and
location.
•
Make sure the sensor low battery icon isn’t
being displayed. Make sure the sensor is
within range of the base unit. Press
RESET
on sensor to initiate a sensor search or
press and hold
TEMP
on the base unit to
search for sensors.
“HI” shows on display
When the outdoor temperature reaches 40 °C (104
°F) or higher, the base unit will display “HI”.
“LO” shows on display
When the outdoor temperature falls below –20 °
C, the base unit will display “LO”.
CAUSES OF POOR RECEPTION
•
Aluminum siding
•
Foil backing on insulation
TW339 manual_Eng 6.p65
3/9/05, 4:21 PM
21
