7
GB
To load new batteries in the chest belt (TS120 and TS130
only) and bike mount:
The chest belt will stop sending signals if its battery is
low. Bad transmission from the chest belt may also be the result
of poor contact with the skin, surrounding interference, or
placing the receiver watch too far away.
To load new batteries in the bicycle sensors and bike
mount:
The sensors will stop sending signals to the watch if
their batteries are low.
Replace the batteries whenever the HIGLO backlight
dims or stops working, or when you see the low battery icon.
NOTE
GETTING STARTED
TURN ON THE WATCH (FIRST-TIME USE ONLY)
Press MODE key for 2 seconds or more to activate the
LCD Display
BATTERIES
All batteries are included and already installed. Refer to the
Specifications page for battery types (
➔
28).
To avoid the possibility of permanently damaging the
watch, we strongly recommend that you take your watch to a
local retailer or jeweler to have the watch battery replaced.
To load new batteries in the watch:
Diagram
Instructions
1. Remove the Lycra strap.
2. Remove the back cover with a small Phillips
screwdriver.
3. Install the battery by matching the correct polarity.
Always use the correct battery type.
Warning: Reversing the polarity may damage the
product.
4. Replace the cover, screws, screw pin, and
watchband. (Be sure to replace the O ring
properly).
5. Check that replacement batteries are fitted properly
by pressing a button. You should hear a beep.
Diagram
Instructions
1. Insert a coin into the grove. Turn counter-clock-
wise.
2. Insert the battery. Match the correct polarity.
3. Replace the battery compartment. Tighten into
place.
Diagram
Instructions
1. Insert a coin into the grove and turn counter-
clockwise.
2. Remove the battery. Remove the battery and
insert a new one.
3. Replace thebattery holder and compartment lid.
Tighten into place.
NOTE
NOTE
NOTE
