Assembly
1. Ensure the power cord is
resting in the cord strain
relief.
Should the power cord come
loose from the cord strain
relief reattach it to preserve
the life of the power cord.
To reattach the cord strain
relief, grasp the power cord
4 - 5 inches from the unit.
Pinch power cord together
and slide approximately
1 - 2 inches through hole in
cord strain relief. Carefully
slide power cord over clamp
on the cord strain relief and
pull excess until the power
cord is seated under clamp
(fig 1).
2. Insert the hose into the
intake and turn clockwise to
lock hose in place
(fig 2).
Operating Instructions
Make sure disposable paper filter dust bag is in place.
DO NOT operate the
cleaner without a paper filter dust bag. Plug the power cord into an electrical
outlet and press the “On” switch located on top of the unit.
High-Low Switch
This machine is equipped with a normal mode/quiet use switch.
You can use it to control the speed of the suction motor.
SWITCH SPEED
ACTION
Quiet Mode
Quiet Mode
Noise Reduction
Suction Reduction
Normal Use
Normal
Increase Noise
Increase Suction
Removing & Replacing the Disposable Dust Filter Bag
1. Release latch on the side of
the unit and remove the top
cover
(fig 3).
2. Remove hose from intake.
Fold ends of filter bag
together and pull cardboard
tag to automatically close
the bag
(fig 4).
3. Insert a new filter bag by
sliding the cardboard collar
into the slots located on the
dock until bag is fully
inserted.
4. Replace hose and top cover
and fasten latch.
Using the Extension Wand & Accessory Tools
Extension Wand: Insert the
nozzle firmly into the large end
of the extension wand. To extend
the wand, push the button on
the wand forward and pull the
extension out to the desired
length
(fig 5).
Accessory Tools: The accesso-
ry tools can be used either with
or without the extension wand.
To attach an accessory tool with
the extension wand, firmly slide
the small end of the extension
wand directly into the desired
accessory tool. To attach an accessory tool without the extension
wand, firmly slide the nozzle directly into the desired accessory tool.
For Easy Power Cord Storage
In order to extend the life of the power cord and prevent fracture, grasp
the cord close to the unit and roll the cord from the machine outwards.
When finished, hang the power cord on the cord hooks
(fig 6).
Operating Recommendations
1. When inserting a new disposable paper filter dust bag–FIRST
PUFF OUT and OPEN THE BAG.
2. When the disposable filter dust bag is full, REPLACE IT.
3. If at any time the unit does not pick up properly or makes an
unusual noise, STOP OPERATION and service.
4. Although your vacuum will pick up pins, paper clips, and other
small objects, it is recommended that these be removed from the
floor before you vacuum. Failure to do so may result in permanent
damage to the unit.
5.
WARNING: Do not use your vacuum cleaner on damp or wet
surfaces. This will cause damage to the vacuum cleaner and is
dangerous to the user. Damage caused by use on wet or damp
surfaces is not covered under warranty.
6. Change the disposable filter dust bag at least once a month–even
if it is not full! The collected dust in the dust bag can cause odor,
attract moisture, and can affect the efficiency of the cleaner.
7.
DO NOT run the vacuum cleaner over the cord.
8.
Use caution when vacuuming over area rug edges & fringe.
4
1
2
3
4
5
6
Cord Strain Relief
Clamp
Summary of Contents for XL COMPACTO 6
Page 7: ...7 ...
