ORBOT SPRAYBORG, Operating Manual

Page: 17 / 39

17
APPLICATION ON DIFFERENT FLOOR TYPES
Carpet Cleaning
Vacuum the carpet thoroughly before cleaning. Large dirt
particles are removed, allowing the application to be more
effective.
Apply solution as you move forward. The carpet should
be cleaned by going forward and backwards two to three
times, while applying solution on the first pass in order to
keep the drying time low. Depending on the level of soil
and the nature of the carpet, this process can be shortened
or extended. As required, carpets can be vacuumed again
after cleaning.
Cleaning Hard Floors
Remove dust and coarse dirt from the surface before
cleaning. Choose a suitable pad according to the
application. Place the pad in the center of the driver.
Gently lower the head on to the floor. Moving forward
and backwards while adding water cleans the surface.
w Use a cleaning solution as needed. Depending on soil
contamination and floor type, this process can be shortened
or extended.
OPERATION / MAINTENANCE
MAINTENANCE
Cleaning the Machine:
Clean the machine and bearing with a soft cloth and a
neutral pH cleaner. Regular cleaning of the bearing is
required to prevent build up that will cause it to seize up.
Changing the driver grip face:
Remove the ten outer screws that fasten the grip face disc
on the driver plate. To save time, use an electric screwdriver with a #3 Phillips Head bit.
WARNING
The Number #3 Phillips head bit is slightly larger than standard size. It is important that you are using a
#3 Phillips Head bit, as smaller bits can damage the screw heads and produce sharp edges which can
damage the cleaning pads. Attach a new grip face disc to the driver plate using the ten screws.
WARNING
Make sure that the screws are very tight, not loose. If the screws are the slightest loose it can cause
damage to the grip face disc. Ensure that the four holes in the middle of the grip face disc are aligned
with the screws located on the driver plate. An exact alignment allows an easy removal and installation of
the driver plate.