ORBOT SPRAYBORG, Operating Manual

Page: 12 / 39

12
OPERATION
wheels down first, followed by the machine base.
WARNING
Make sure not to grip too close to the machine base. If the
base should flip upwards it can cause serious hand injuries.
Make sure you lift the machine with a back-friendly posture.
Secure machine firmly so it will not move.
Weight Kit Installation
The total weight of the weight kit is 40 lbs.
Put the weights on top of the mounting plates located on the
sides of the machine base.
Put the four screws into the holes provided on the weight
plates and fasten by turning clockwise.
Once the screws have threaded at least 5 full turns, tighten
the wing nuts by turning them clockwise, until the weights fit
securely to the base.
CAUTION
Make sure that the weights are securely attached to the
base. Loose weights can cause serious damage.
For storage and transport we recommend removing the
weight kit. The machine can be transported more easily
without the weights.
Brush Installation
Put the machine base in an upright position, sitting on the
foot of the bumper.
Remove the driver plate by removing the four countersink
screws in the center of the plate using an electric
screwdriver.
WARNING
It is important to only use a Number 3 Phillips head
screwdriver bit. Smaller bit sizes can damage the screw
heads and leave sharp edges, which can tear or snag the
pads. Damaged screws can cause further damage.