Operating instructions SCORP
6 Operation
orbitalum tools
gmbh
(06.07)
MT_SCORP_BA_04_790014762_09.doc
17
3. Press the operation handle (13) downwards until the saw blade / cutting
disc has cut through the wall of the pipe and the machine motor is running
freely.
When the release button (14) springs back to its fixed position, the saw blade
is fixed in its cutting position and the sawing operation can now begin.
The cutting speed depends upon the material and pipe wall thickness (the
most favourable speed can easily be judged by hand). A too high cutting speed
can damage the saw blades and overload the SCORP.
The pipe saw is equipped with overload protection. When the blade is dull or
the speed is too high, the overload protection cuts power automatically.
Restore the power by pushing the overload protection switch (switch for
overload protection, see chapter 2.1, p. 6).
4. Cutting always takes place in opposite direction, as the pipe is turned to the
operator and the SCORP in opposite direction.
Should the cutting operation need to be stopped before the pipe has been fully
cut you must:
X
Free the pipe, by using the release button (14) so that the motor part of the
SCORP can be elevated to its uppermost position.
Material damage
:
Never
start the motor if the SCORP is stopped in the cutting position or if
the teeth of the saw blades are still in contact with the pipe material.
Note
Overload protection
Pipe cutting
To stop the
cutting operation
Attention
14
13
Summary of Contents for SCORP 220 Plus
Page 27: ......