20
INSTRUCTIONS FOR USE OMX 100
4.2.2 CONFIGURATION MODE - CHANNELS
+
CHA.
SER.
OUT.
INP.
SET
FOR.
FIL.
DES.
In this menu instrument parameters are set
SET
Setting the display
projection for minimum/
maximum value of the input signal
FIL.
Setting the digital filters
FOR.
Setting the decimal point
DES.
Setting the measuring units
Input type
Setting options
DC
AC
PM
DU
OHM
RTD
T/C
F
4.2.2.1 DISPLAY PROJECTION
DC
PM
DU
OHM
F
+
CHA.
SER.
OUT.
MIN
MAX
INP.
FIL.
FOR.
DES.
SET
MIN.
Setting the display
projection for minimum value
of the input signal
- range of the setting is -99…999
MAX
Setting display projection
for maximum value of the
input signal
- range of the setting is -99…999
SCA
Setting the calibration
constant
- calibration constant is for the conversion of
input value to required display value
- by setting the minus value the direction of
counting changes, i.e. we count down
- range: -0,00001...999999,
DEF
= 1
OFF
Setting the additive constant
„PRESET“
- shifting the beginning of measurement by
a set value which will always be read upon
resetting the instrument to zero
- range: -99999...999999,
DEF
= 0
Only for type „F“
Items „MIN“ and „MAX“ resp. „SCA“ and „OFF“ are
displayed only when the menu is set to „Manual“
INP > CFG > CH.S > MAN
+
CHA.
SER.
OUT.
SCA
OFF
INP.
FIL.
FOR.
DES.
SET
Summary of Contents for OMX 100 Series
