background image

INSTR,INSTL,DXS-32
LINEAR P/N: 216314 B
MATERIAL: 20 LB. MEAD BOND
SIZE: 8.500" X 11.000"
INK: BLACK
SCALE: 1-1
SIDE 1 OF 2

DXS-32

MINIATURE
SUPERVISED
DOOR/WINDOW
TRANSMITTER

Installation Instructions

PRODUCT DESCRIPTION

The DXS-32 is a battery powered stationary transmitter designed for use with Linear’s DXS and DX
format receivers. This transmitter can be used in a variety of wireless remote control applications.
Triggering the transmitter with its built-in magnetic switch sends a digitally coded wireless signal to
its companion receiver.
The digital DXS code format features over a million possible codes. The DXS transmitters are
precoded at the factory to unique codes, so no field coding is required. The DXS-32 can send four
different codes: alarm, restore, low battery and status.
Receivers must be programmed to the transmitter’s code before system testing and operation. Refer
to the receiver’s instructions for details on programming.
In a typical installation, the magnet is mounted on a door or window and the transmitter is mounted
on the frame. When the magnet moves more than 1/2" away from the transmitter, an alarm signal is
sent. When the magnet returns next to the unit, a restore signal is sent. The magnet is adjustable
with four height positions. A 1/4" high magnet spacer is also supplied to snap on to the base of the
magnet.
The transmitter is powered from two 3-Volt #2032 lithium batteries with an expected battery life of
up to 4 years. Every hour, the DXS-32 will send a status transmission to the receiver. The hourly
signal updates the receiver to the transmitter’s condition. By monitoring status transmissions, the
receiver can determine if a transmitter has a low battery or has been removed from the system. DXS
format receivers can monitor status signals, DX format receivers cannot.
Normally, the transmitter sends an exit/entry delay transmission code. Cutting an internal jumper
selects an instant transmission code. Cutting this jumper doesn’t change the time of the actual
transmissions, but changes the code of the signal sent so the receiver can determine the transmitter’s
function.

(760) 438-7000 • FAX (760) 438-7043

USA & Canada (800) 421-1587 & (800) 392-0123

Toll Free FAX (800) 468-1340

www.linearcorp.com

BY

DXS-32 FEATURES & ACCESSORIES

OPENING CASE

REMOVE BATTERY PROTECTION STRIP

COMPONENT LOCATIONS

MAGNET

SCREWS AND

DOUBLE STICK TAPE

ADJUSTABLE

MAGNET

SQUEEZE MAGNET TABS TO

ADJUST MAGNET HEIGHT (4 POSITIONS)

MAGNET

ADJUSTMENT

TAB (EACH SIDE)

TRANSMITTER

SCREWS AND

DOUBLE STICK TAPE

MAGNET CAN BE MOUNTED UP TO

1/2" FROM LEFT SIDE OF

TRANSMITTER

MAGNET

SIDE

MARK

TRANSMITTER

MAGNET

ALIGNMENT

MARKS

MAGNET

ALIGNMENT

MARKS

REMOVE THE CASE TOP BY TWISTING A
SMALL FLAT BLADE SCREWDRIVER IN
THE SLOT ON EITHER END OF THE TRANSMITTER

TWIST

PULL OUT & DISCARD
BATTERY PROTECTION
STRIP TO ACTIVATE
TRANSMITTER

TWO TYPE 2032
BATTERIES

ANTENNA

DELAY/INSTANT JUMPER
(CUT JUMPER FOR INSTANT)

Reviews: