Orbit baby Double Stroller Kit, Manual

Page: 16 / 32

8 – ENGLISH
– Manual Text Booklet – Orbit Baby Double Stroller Kit
Installing your new Unibar
⚠
WARNING
⚠
◦
Proper assembly is required. Check that Unibar is properly installed and screws are tight.
⃞
Remove the two loose Phillips screws from the metal clamps in the bottom of the Unibar assembly;
keep them handy. Lock the brakes by pressing firmly down on the right brake pedal
Ⓢ
with your
foot. Install the new Unibar assembly by aligning the water bottle tray
Ⓙ
to the exposed aluminum
handlebar tubes and pushing evenly on both sides in short, hard bursts. Push the water bottle tray
down until it completely covers the square cross tube with screw holes completly visible below
cross tube.
⃞
Completely tighten both thumbscrews into the metal inserts in the water bottle tray. Re-install the
two Phillips screws you removed from the metal clamps in the water bottle tray. Tighten the screws
completely using a Phillips screwdriver.
Installing your wheel disks
⚠
WARNING
⚠
◦
Proper assembly is required. Check that wheel disks are properly installed and fasteners are
tight. Shake rear wheels after installation to ensure neither the disk nor the cap move or rattle.
⃞
Remove both rear wheels from the stroller frame by pulling down on the bent metal tab behind
the wheel and pulling the wheel outwards. Remove the three Phillips screws that are loosely
fastened into the wheel disk using a Phillips screwdriver tool. Insert a wheel disk
Ⓤ
into the inside
of each wheel, lining up the spokes and slots in the wheel disk. Insert the wheel disk cap
Ⓣ
on the
outside of each wheel lining up the screw holes with the bosses on the wheel disk. Using a Phillips
screwdriver tool, fully tighten the three mounting screws to secure the wheel disks and caps to the
rear wheels. Check your installation by shaking the rear wheel and ensuring neither the disk nor the
cap move or rattle.