Model Reset:
Resets a model to factory default settings.
1. Use the wheel to select a memory slot for the model.
2. Press the wheel to select and then move the wheel to select yes and press the wheel again.
3. If needed press the cancel key to exit without saving.
Model copy:
Copies a model from one memory slot to another.
1. Use the wheel to select a model to copy and press the wheel.
2. Use the wheel to select a memory slot to copy to.
3. Press and hold the wheel and then move the wheel to select yes.
4. If needed press the cancel key to exit without saving.
Flaps:
Flaps increase lift at lower airspeeds by increasing the camber of the wing or, in some cases,
increasing the camber and surface area of the wing, this is quite useful during landing and take off.
If your model has flaps this function will set the [UP] and [DOWN] positions for the flaps. The flaps
can also be controller by a switch, knob or logic gate. This function can also mix flap movement to
ailerons.
Setup:
1. Use the wheel to enable the flaps function and press the wheel.
2. If needed use the wheel to set a switch and press the wheel.
3. Use the wheel to set the flap position and press the wheel.
4. Use the wheel to set the Elevon position.
5. Press and hold the wheel to save an exit, or press the cancel key to exit without saving.
17
6 CHANNEL TRANSMITTER
DIGITAL PROPORTIONAL RADIO
CONTROL SYSTEMPROGRAMABLE SYSTEM
