Oracle X8-8, Installation Manual

Page: 60 / 134

Back Panel Connectors and Ports
Callout Description System/SMOD Available On...
8 NET0, NET1, NET2, and NET3 ports: See
“Ethernet Ports” on page 62
System A –
SMOD0
All systems
9 Power connectors 2 and 3. Connect to 200-240
VAC only. See “Connect Cables and Power
Cords” on page 64
System A –
SMOD0
Always connect all four power
supplies
10 Power connectors 0 and 1. Connect to 200-240
VAC only. See “Connect Cables and Power
Cords” on page 64
System B –
SMOD1
Always connect all four power
supplies
USB Ports
Each SMOD has a single external USB 3.0 port. The USB port supports hot-plug insertion and
removal. You can connect and disconnect a USB cable or a peripheral device while the server is
running without affecting server operations.
■
For a single 4-socket system, the USB port on SMOD0 connects to System A and the USB
port on SMOD1 is inactive.
■
For a dual 4-socket system, the USB port on SMOD0 connects to System A and the USB
port on SMOD1 connects to System B.
■
For a single 8-socket system, both USB ports connect to System A.
See the location of the USB ports at “Back Panel Connectors and Ports” on page 58 .
Each USB port supplies 5V output at 2A.
Related Information
■
“Back Panel Connectors and Ports” on page 58
■
“Cabling Requirements” on page 57
SER MGT Ports
The SER MGT RJ-45 port, located on the SMOD rear panel, provides the default management
connection to the Oracle ILOM SP. The service processor SER MGT port uses an RJ-45 cable
and terminal (or emulator) to provide access to the Oracle ILOM command-line interface (CLI).
Using Oracle ILOM, you can configure it to connect to the system console. Each SMOD has
60 Oracle Server X8-8 Installation Guide • June 2019