Oracle SPARC T8-4, Installation Manual

Page: 80 / 92

Auto Service Request Software
commitpending = (Cannot show property)
dhcp_clientid = xxx.xxx.xxx.xxx
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx
ipnetmask = 255.255.255.0
macaddress = xx:xx:xx:xx:xx:xx
managementport = MGMT
outofbandmacaddress = xx:xx:xx:xx:xx:xx
pendingipaddress = service-processor-IPaddr
pendingipdiscovery = static
pendingipgateway =
gateway-IPaddr
pendingipnetmask = 255.255.255.0
pendingmanagementport = MGMT
sidebandmacaddress = xx:xx:xx:xx:xx:xx
state = enabled
6. Set the changes to the SP network parameters.
-> set /SP/network commitpending=true
Set 'commitpending' to 'true'
Note - You can type the
show /SP/network
command again to verify that the parameters have
been updated.
Related Information
■
“Configure the Preinstalled OS” on page 71
■
“Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 72
■
“Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)” on page 74
■
“Oracle Solaris OS Configuration Parameters” on page 76
■
SPARC T8 Series Servers Administration Guide
■
Oracle ILOM documentation
Auto Service Request Software
Oracle systems with Oracle Auto Service Request securely transport electronic fault telemetry
data to Oracle to expedite the diagnostic process. Oracle ASR software provides the ability to
automatically notify Oracle Support and opens a service request on your behalf when specific
hardware faults are detected.
80 SPARC T8-4 Server Installation Guide • September 2017