Oracle Fabric Interconnect F2-12, Installation Manual, Page: 83 / 118

Assign a Static IP Address to the SP
3. Log in to the SP with user name
root
and password
changeme
.
hostname
login: root
Password: changeme
->
The
->
prompt is displayed.
Note -
You can change the password at a later time. Refer to the Oracle EDR InfiniBand Switch
and Virtualized I/O System Administration Guide , changing the administrator password.
4. Consider your next task.
■
If you have a full-time SER MGT connection, go to “Verify LED
Status” on page 89 or “Assign a Static IP Address to the
SP” on page 83 .
■ If your SER MGT connection is only temporary, go to “Assign a Static IP
Address to the SP” on page 83 .
Related Information
■
“Connect the SER MGT Cable” on page 75
■
“Connect a Serial Management Device to the SER MGT Port” on page 77
■
“Connect Power Cords” on page 77
■
“Power On the Switch” on page 81
■
“Assign a Static IP Address to the SP” on page 83
■
“Assign a Static IP Address to the SCP” on page 85
■
“Log In to the SP (Network Management)” on page 86
Assign a Static IP Address to the SP
The switch ships with DHCP IP address assignment for the SP.
1. Identify the prerequisite and subsequent installation tasks that you must
perform in conjunction with this task.
See “Installation Task Overview” on page 11 .
2. Access the Oracle ILOM CLI.
See “Log In to the SP (SER MGT)” on page 82 .
3.
Configure the network management parameters.
-> set /SP/network
property
=
value property
=
value
...
Powering On the Switch 83