Oracle Fabric Interconnect F2-12, Installation Manual, Page: 82 / 118

Log In to the SP (SER MGT)
■
Both the SP and SCP are powered on and booting up.
Note - You might see the boot sequence on the serial device.
■
The SP LED blinks slowly.
When the SP LED stops blinking and stays lit, and the OK LED lights, it is possible to log in to
the SP.
4.
Consider your next steps.
■
If you have DHCP-assigned IP addresses, log in to the SP through the
network.
See “Log In to the SP (Network Management)” on page 86 .
■
Otherwise, log in to the SP through the SER MGT port.
See “Log In to the SP (SER MGT)” on page 82 .
Related Information
■
“Connect the SER MGT Cable” on page 75
■
“Connect a Serial Management Device to the SER MGT Port” on page 77
■
“Connect Power Cords” on page 77
■
“Log In to the SP (SER MGT)” on page 82
■
“Assign a Static IP Address to the SP” on page 83
■
“Assign a Static IP Address to the SCP” on page 85
■
“Log In to the SP (Network Management)” on page 86
Log In to the SP (SER MGT)
1. Identify the prerequisite and subsequent installation tasks that you must
perform in conjunction with this task.
See “Installation Task Overview” on page 11 .
2.
On the serial management device, press the Return or Enter key several times to
synchronize the connection.
The login prompt is displayed.
hostname
login:
where hostname is the host name of the SP. If no host name is assigned,
ORACLESP-unknown
might be displayed.
82 Oracle Fabric Interconnect F2-12 Installation Guide • November 2016