Oracle Fabric Interconnect F2-12, Installation Manual

Page: 81 / 118

Power On the Switch
7.
Power on the switch.
See “Power On the Switch” on page 81 .
Related Information
■
“Connect the SER MGT Cable” on page 75
■
“Connect a Serial Management Device to the SER MGT Port” on page 77
■
“Power On the Switch” on page 81
■
“Log In to the SP (SER MGT)” on page 82
■
“Assign a Static IP Address to the SP” on page 83
■
“Assign a Static IP Address to the SCP” on page 85
■
“Log In to the SP (Network Management)” on page 86
Power On the Switch
When live power is delivered to the receptacles at the rear of the chassis, standby and main
power is made available by the power supplies. The switch immediately comes to full power.
Both the SP and SCP begin their boot processes.
1. Identify the prerequisite and subsequent installation tasks that you must
perform in conjunction with this task.
See “Installation Task Overview” on page 11 .
2.
Ensure that:
■
Nodes of the IB fabric and hosts of the Ethernet and Fibre Channel networks are operational
and securely cabled to the switch.
■
Serial management console is operational, configured with correct parameters, and
cabled to the switch. See “Connect a Serial Management Device to the SER MGT
Port” on page 77 .
■
Management network is operational and securely cabled to the switch.
■
Facility power source or power distribution device is properly cabled to the switch,
available, and standing by.
■
All data, management, and power cabling to the switch is secure at the switch.
3. Energize the circuit breakers so that facility power is delivered to the switch.
These actions occur in order:
■
All chassis status LEDs illuminate, then go dark.
■
The power supply LEDs indicate input power, then output power.
■
The fans spin up.
■
Full power is applied to all circuits and systems inside the switch.
Powering On the Switch 81