2.
Pull on one of the two captive screws and support the base of the SSD as you
pull it out of the chassis to remove it. Please place the removed SSD in an
ESD-sensitive location.
Removing the SSD
Installing the SSD
The procedure in this section describes how to install the SSD into the Acme Packet
6300/6350.
Prerequisites:
•
#2 Phillips screwdriver or a bladed screwdriver
•
Place the SSD in an ESD-safe location.
•
Wear an ESD wrist strap or take similar equivalent actions to prevent static
damage to the SSD or other ESD-sensitive components.
To install an SSD:
1.
Insert the new SSD into the empty SSD slot on the top left rear of the Acme
Packet 6300/6350 chassis.
2.
Push on the face of the SSD to properly seat the connectors with the chassis as
shown below. When seated properly, the face of the SSD will be flush with the
exterior of the chassis.
Chapter 6
Replacing the SSD
6-29