Oracle 1242, User Manual

Page: 77 / 84

Servicing the Top Panel and Top Cable Window
5.
Swing the lower edge of the upper panel outward about 6 inches and reconnect
the grounding straps [2].
Mate the two ends of the banana jack to complete the connection.
Note -
If the rack is full, you might not be able to access the grounding straps once the panel is
in place.
6. Swing the lower edge of the upper panel inward, lift the panel slightly using the
handle, and lower the tabs into the grooves [3].
The two lower tabs are located in the center of the upper panel, near the handle.
7. Use the keys to lock the upper panel.
The panel is locked when the key slot is in the vertical position.
8. Power on the rack.
See “Power On the Rack” on page 53 .
Servicing the Top Panel and Top Cable Window
The rack has a top panel that covers most of the top of the rack, and a top cable window that
you can use to route data and power cables.
■
“Remove the Top Panel” on page 77
■
“Install the Top Panel” on page 78
■
“Remove and Replace the Top Cable Window” on page 79
Related Information
■
“Servicing Doors” on page 62
■
“Servicing Filler Panels” on page 67
■
“Servicing Side Panels” on page 70
Remove the Top Panel
Before You Begin
This procedure requires a step stool or ladder and a T-25 Torx screwdriver.
Servicing the Rack 77