NOTE:
If the network is DHCP-enabled and no outbound ports are blocked, skip to
"Requirements for the OPW Ethernet IP Authorization Gateway" below. Otherwise, proceed
with the information as follows below.
NOTE:
The following ports must be open for outbound traffic; 53, 80, 123, 443, 10001, 10002.
IMPORTANT:
If the site chooses to use the Inbound Communications option, then a Static IP
Address must be programmed into the unit regardless of whether the LAN is dynamic or static,
and the below information must be provided.
If this is a
Static IP
LAN environment, enter the
IP Address
:
Enter the
Subnet Mask
:
Enter the
Default Gateway
:
Enter the
DNS
(Domain Name Server) 1:
Enter the
DNS
(Domain Name Server) 2:
If a
Static IP Address
is required, the OPW Help Desk will configure it for you once you have completed the
following steps:
1. Plug the IP Authorization Gateway into a DHCP-capable router (this may be at your office before you
arrive onsite).
2. Verify that the
status light
on the Ethernet IP Authorization Gateway is green and blinking once per
second.
3. Verify the last six (6) digits of the MAC address located below the barcode on the bottom of the IP
Authorization Gateway:
n
000:80:44
: ________________.
2.2 Requirements for the OPW Ethernet IP Authorization Gateway
Call Abierto at 888-216-6823 for assistance. You will need the items that follow
l
A Laptop Computer to be used for troubleshooting any connectivity issues that may arise on-site.
l
One (1) OPW IP Gateway Converter (model #20-6013) with two (2) 20-1517-01 Modem Cables.
l
Two (2) standard CAT5 cables (one for communications from the router/switch to the Gateway
Converter, one to connect a laptop to the router/switch for troubleshooting communication issues).
l
For model
20-6013
: (fill in the appropriate blank fields)
n
CFN Site ID#: ____________________________
n
TCH Site ID#: ____________________________
Doc. No.: M00-20-6013 Rev.: 0
Page 8 of 14
Summary of Contents for PetroVend M00-20-6013
Page 14: ......
