Section 2 OPW Ethernet IP Authorization Gateway
Installation
Prior to the installation of the OPW Ethernet IP Authorization Gateway, an initial site assessment, gateway
requirements and network connectivity must be established. Follow the installation procedure below for
connecting the OPW Ethernet IP Authorization Gateway.
NOTICE:
Never press the
reset
button on the IP Gateway. This will erase the program and
it will have to be reloaded. There is a fee associated with reloading the program.
NOTE:
Refer to the
M1700 FSC3000 Installation Manual
for connection information between
the Gateway and the FSC3000.
For support plan and setup information contact Abierto Networks at (888) 216-6823 8:30 am - 5:30 pm
Eastern Time. Refer to
"Important Abierto Service and Warranty Information" on page 5
for information.
NOTE:
Before you call Abierto you must have your device's MAC address. This can be found
on the device's label on the bottom of the unit.
2.1 Site Assessment for the OPW Ethernet IP Authorization Gateway
For 20-6013 network users, prior to installation, the site assessment must be completed and the OPW Site
Request Form must be faxed to the number at the top of the form, after which network users must activate
their ControlScan Account, which will be sent to the site owner via email.
NOTE:
There is a monthly charge for an EchoSat Account.
IMPORTANT:
The OPW Site Request Form must be submitted 48 hours prior to your planned
install time.
Prior to installing any version of the Ethernet IP Gateway, collect the following information or provide this
document to the IT Manager so that the following information can be filled in.
l
Is the LAN (internal) network at the site DHCP-enabled (dynamic)?
Yes
No
l
Are there any outbound port-blocking rules in place on the network?
Yes
No
Doc. No.: M00-20-6013 Rev.: 0
Page 7 of 14
Summary of Contents for PetroVend M00-20-6013
Page 14: ......
