Setting up your OP15
Setting up your OP15
PAGE: 9
STEP 9
Using one hand or a helper to hold the roof panel up, pull and rotate the spring bolt that secures the side panel until it is in the vertical position.
This will allow the side panels to swing outwards.
STEP 10
Open the left side panel fully through 90 degrees, ensuring the panel meets the top left corner groove of the roof panel to complete the set-up
and achieve a full seal. Repeat with the right ride panel.
STEP 11
Holding the bed panel securely, release the two rear bed panel securing latches and fold down the bed panel.
WARNING
Please ensure you or a helper are holding the fold down bed panel before releasing the latches as this panel can shift if you are on any incline or
the camper is not completely level. Failure to support the panel fully at this point could result in serious injury or damage to the trailer.
STEP 12
Carefully lower the rear bed panel into the horizontal position.
STEP 13
Use the handle to lift the rear end wall panel in place. Slide the two locking pins in place and then secure with the latch clamps.
WARNING
Please ensure you or a helper are holding the fold down bed panel before releasing the latches as this panel can shift if you are on any incline or
the camper is not completely level. Failure to support the panel fully at this point could result in serious injury or damage to the trailer.
