Opus MultiCREASE 30, User Manual

Page: 4 / 16

MutliCREASE 30 - User’s guide
EN
PREPARATION TO WORK
• The machine do not need to be uninstall with the transporting protections.
• It is suggested to store the packaging in case of future transports.
• The machine should be placed on a stable, flat and durable surface.
• Rubber legs protect against surface damages and do not leave marks.
• With the machine there are enclosed:
- Creasing device
- Corner cutter with the gauge adjusting device and the pad
CREASING
Put the creasing unit on the bar located in
the machine slot and push it down
(see the picture). Distinctive click sound
informs about proper unit installing.
Using front or back gauges set the position
of the crease. Put the material under the bar
and press the arm down.
Note!
During creasing do not press the arm till
the end. If the pressure is too high damaging
the bar is possible.
Changing the creasing bar
Remove the creasing bar from the creasing unit. Take off the strip covering the glued side in the new
bar and place it on a creasing knife using rubber, shaped gauge. Press the bar and remove the rubber
gauge.
CORNER CUTTING
Adjustment
Place the corner cutter (1) and the gauge adjusting
device (2) on the handle in the housing – the
handle on the corner cutter should be directed
to the cover and the knife should be in upside
position. Match the gauges of the cutting unit
with the knife by pressing the device to the blade.
Place the corner cutter on the bar. Move the pad,
with the material to be rounded, to the gauge
and press the arm down.
5
4
6
Changing the knife in the corner cutter
Draw the gauges apart to assure easy access
to the blade. Push the knife by pressing its
base and next install new blade.
Because of sharp edges of the blade it is
important to follow safety precautions
during it changing – the risk of injury.
PUNCHING
Place the pad under the bar. Put the material, with the cutting blade on it.
Press the arm down. It is suggested to cut it in several phases/ several move of the lever.
Note!
It is suggested to use die-cuts with 19mm blade high offered by the manufacturer to achieve
the best results with the machine
7
8 Technical data:
Max creasing width: ................300 mm
Max thickness
of the creased material: ............0,3 mm
Creasing bar thickness: ........0,7 mm (2Pt)
Net weight: ..............................17,5 kg
Gross weight: ..........................19,5 kg
Size (W x H x D): ......550 x 380 x 270 mm
04.01.10
6 7