Please take care during machine operation
– pressing the hand, even with the
cold heater, can cause body injuries
Turn off the machine using main switch after finished work. The machine is
turned off completely after removing the plug from a socket
General Information:
The Master-Press was designed to make embossing and/or foil stamping on paper
or cardboard covers, as well as on covers coated with paper veneer. It is also
possible to make hot stamps on plastic or plastic coated covers, however
previously the tests should be carried out to check if the material is suitable for foil
stamping/embossing.
The use of fonts makes possible composing any inscription (there are available
various kinds of fonts, also in various languages and sizes) and marking it on the
cover or other surface. It is also possible to prepare a special matrix (e.g. a logo)
consistent with the GOLDCOVER standard. The detailed information concerning
extension of the possibilities of the machine can be obtained from the supplier.
Operation of the machine does not need special qualifications, however:
Before starting the work operator should read the user’s guide carefully
In separate offer they are also available:
O.Matrix Frameworks MP was designed to install matrixes into Masterpress
hot stamping equipment. You can order a special, customized logos/cliché
(O.Matrix MP) from OPUS, of your own design or you can use your own
logos/cliché. In both cases O.Matrix Frameworks are necessary to put the
matrix into the heating slot, however to fit your own matrix a special tape
(O.Mounting Tape) and a plate called (O.Matrix Base MP) are also required.
A. Preparing the customer matrix (using O.Matrix Base MP)
1. R
emove the protection layer and stick the O.Matrix tape to
the back of your matrix then cut it along the matrix edge.
2. R
emove second protection paper and stick the matrix to
the O.Matrix Base MP.
Note!
Before sticking the matrix, make sure that the inscription/logo on the matrix is
parallel to the bottom edge of the plate (O.Matrix Base MP).
B. Assembling the O.Matrix Framework MP (both to O.Matrix and O.Matrix
Plate MP)
1.
Screw down O.Matrix Frameworks MP to the O.Matrix MP or O.Matrix Base MP
with 4 bolts.
Note!
In order to screw down the bolts please use the screwdriver, which is supplied to
the Master Press Hot Stamping equipment and also is use to adjusting guides in
frames for fonts.
Note!
The heating time of a matrix depends on its size and can vary from 5 to 10
minutes. It is necessary to conduct a test to check if the matrix is hot enough.
Design of the machine:
