Operating, Maintenance and Health Safe
Manual
MasterPress 01
Safety instructions:
Before putting the equipment into operation, please read the Health & Safety
precautions, manufacturer recommendations and the operation manual.
The user’s guide should be easily available at any time for the operator.
The equipment should be fixed to the stand supplied and placed on a strong
solid flat level floor, to ensure safe operation. We recommended that you
screw down the base to the floor were possible.
The equipment should be protected against dust and moisture
= must not be placed near heating or ventilation units
= must not be used in vicinity of inflammable liquids or gases
= may be supplied with power only through the original cord.
A mains socket should be provided with in accordance with electrical and
earthing regulation.
The supply voltage should be consistent with the specifications on the
technical plate located on the machine housing and in the technical data
sheet.
Failure to do so may result in electrical shock or fire and cancel guarantee.
The electrical supply cable should be protected against damage, and must not
be used to pull the machine or to remove the plug from a socket
Making any changes to the electrical installation of the equipment or supply
cable can causes a fire hazard or electric shock and cancel the guarantee.
During long none use of the equipment, the plug should be removed from the
mains socket
Before removing the housing from the equipment, remove the plug from the
socket.
The electrical system is protected by a 8A fuse next to the power-switch at the
rear.
Before replacing the fuse, remove the plug from the mains socket.
When replacing the fuse it must be of the same type.
If the new fuse goes when replaced contact the service team.
Do not touch the heater
–
burn hazard!
Before fitting new typeface fonts in the frame wait for 5
– 10 minutes to make
sure that they have cooled down
–
burn hazard!
The equipment must be kept away from children and animals.
The equipment must not be used for any other purposes other than those
indicated in the user’s guide
It is necessary to check that the equipment is being operated correctly. In case
of any malfunctions, contacting the service team is required.
The machine must not be located outside, should be operated in a room
temperature higher than 8
o
C
The equipment should be operated in accordance with general Health & Safety
rules
Any repairs can be made only by trained and qualified staff.
Do not use any solvents when clearing the equipment
