(O.Matrix frame or O.Matrix/1L4 frame -
depending on the matrix size).
2. Insert the frame into the heating slot and
wait until the matrix is hot.
Customer`s matrix
1. Stick the tape to the back of your matrix
(by taking off the protection layer) and
cut it along the matrix edge.
2. Stick the matrix to O.Matrix Base
Note!
Before sticking the matrix, make sure
that the inscription/logo on the matrix is
parallel to the bottom edge of the plate
(O.Matrix Base)
3. Put the plate (O.Matrix Base) with the
matrix into the frame (O.Matrix frame)
4. Insert the frame into the heating slot and
wait until the matrix is hot.
Note!
The heating time of a matrix depends on
its size and can vary from few to tens of
minutes. Therefore it is necessary to
conduct a test to check if the matrix is
hot enough.
Preparing the document
for hot stamping
1. Center a cover with the ruler located
along the drawer edge.
2. Determine the height of the inscription
using the scale on the side guide and,
subsequently, set the rear and side
guides.
3. In order to cut foil off, pull a suitable
piece of foil under the knife (preferably,
the foil area should be larger than that of
the heater) and pull it vigorously
upwards. You can also remove the knife
and cut the foil in any other place.
4. Arrange the plates depending on the
type of covers to be hot stamped.
Preparing the plates
A. ADJUSTMENT
1.Lower the basic plate (3) by turning all its
knobs maximally counter-clockwise and
place it into the heating slot of the
Gopdpress 4+ machine.
Note!
The plate should be put directly into the
heating slot by lifting it up a little (do not slide
it into the slot).
2. On the basic plate (3) put the plate #1
and then plate #2.