SAFETY INSTRUCTIONS:
• Before putting the machine into operation please
read the safety precautions, manufacturer recommen-
dations and the operation manual. The operation
manual should be easily available at any time for the
operator.
• The machine should be installed on sturdy and
level floor .
• The machine should be protected against dust
and moisture.
• The machine must not be placed near the heating
units or ventilation units.
• The machine should not be used in vicinity
of inflammable liquids or gases.
• The machine may be power supplied only through
the original cord. A mains socket should be provided
with an efficient earthing. The supply voltage should
be consistent with the parameters specified on the
technical plate located on the machine housing.
If this principle is not obeyed, then electric shock
and fire may occur.
• The supplying cable should be protected against
any damage, must not be used to pull the machine
or to remove the plug from a socket .
• Making any changes to the electric installation of the
machine or in the supplying cable causes the hazard
of electric shock.
• The machine is turned off completely after removing
the plug from a socket.
• During a long standstill or before replacing the
machine, the plug should be removed from a mains
socket.
• Before removing the housing from the machine,
remove the plug from a socket necessarily.
• The power pack module is installed in the machine
base and provided with a mains fuse (access from
the bottom of the machine). If replacement of the
fuse is necessary, this should be effected by a suitably
qualified person.
• Do not touch the heater – b
bu
urrn
n h
ha
azza
arrd
d..
• Before replacement of fonts fixed in the frame, wait
5÷10 min to make sure that the elements are cool
– b
bu
urrn
n h
ha
azza
arrd
d.
• The machine includes a sharp device (knife to cut
off the foil) – pay special attention when using the
device or operating nearby.
• The machine should be kept away from children reach.
• The machine must not be used for any other pur-
poses than those indicated in the operating manual
• It is necessary to check if the machine operates
correctly. In case of any malfunctions, contacting
the servicing point is required
• The machine must not be located outside, should be
operated in room temperature higher than +8C/46,4 F.
• The machine should be operated according to general
safety rules.
• Any repairs can be made only by trained staff.
LCD display
frame
foil
bail
scale
knife
to cut off the foil
ruler
arm
main
switch
guide
incision
in the guide wall
drawer
Design of the machine
holder to support
the frame
