AthAbAscA EAsEL
— ASSEMBLY INSTRUCTIONS
Page 3
underneath the holes to keep the (B) Adapter in place. Put the (G) Long Bolts into the aligning holes on the sides of
the (5) Side Legs. Use your (–) Slot Screwdriver to turn the (B) Adapters so that the slot lines up with the direction
of the (G) Bolts. Use the (A) Hex Wrench to screw in the Bolts into the Bolt adapters and loosely tighten.
6.
Get the (H) 2 Short Bolts, 2 of the (B) Bolt Adapters, the (A) Hex Wrench and the slot screwdriver. To attach
the (2) Upper Cross Bar to the (5) Side Legs place the 2 (B) Bolt adapters into the holes on the inside edge of the (5)
Side Legs directly above the (2) Upper Cross Bar. The (H) 2 Short Bolts go in the back of the (2) Upper Cross Bar.
Proceed to tighten as in previous step.
Assembling the Canvas Support:
7.
Unscrew the knob on the (7) Top Canvas Holder so that
the knob bolt is flush on the other side. Place a (C) Metal
Guard into the channel side of the (7) Top Canvas Holder. The
two tabs of the (C) Metal Guard fit into the two holes above
and below the imbedded nut. Making sure the (C) Guard does
not fall out, feed the flared in channel of the (C) Guard onto
the flared out rail of the (7) Canvas Holder on the same side as
the (6) Center Slide Post. Tighten knob on the (7) Top Canvas
Holder to fix in place and loosen to move up and down.
8.
Insert the bottom of the (6) Center Slide Post into the
groove provided on the back of the (8) Canvas Brush Tray.
Make sure all the holes are aligned (you can use the method
described previously), including the two screw holes on the
bottom of the (8) Tray for the Ratchet Catch (½ of the catch
is already attached to the bottom of the (6) Center Slide Post.)
Use the last 4 (D) Large Screws to attach the (6) Post to the
back of the (8) Tray, and the (F) 2 Small Screws to attach the
Ratchet Catch to the bottom of the (8) Tray (Pg. 4 image).
8.
Ratchet Catch
7.
7.
