AthAbAscA EAsEL
— ASSEMBLY INSTRUCTIONS
Page 2
Assembling The Support Frame:
Tip:
We recommend assembling the easel entirely before tightening all of
your hardware.
Note:
To make assembly easy, the wood parts have pre-drilled holes for
all the screws, bolts and bolt adapters.
1.
Use the (E) 2 medium screws and the appropriate sized (+) Phillips
screwdriver to screw on the two arms of the (1) Center Slide Post
Support to the top protrusion of the (2) Upper Cross Bar.
2.
Insert the tongue on top of the (3) Center Ratchet Post into the slot
on the bottom of the (2) Upper Cross Bar.
3.
Lift the leg of the (3) Ratchet Post & Rear Leg Unit and use two of
the (D) large screws to screw the (4) Lower Cross Bar onto the bottom
front of the (3) Ratchet Post. Make sure the (4) Lower Cross Bar is facing
the right way, shorter edge towards the top.
Note:
To make it easy to line up the holes, screw in the (D) 2 screws on
the (3) Center Ratchet Post only, until the screw points are just poking
out on the ratchet side (stair-like metal strip) and then place the (4)
Lower Cross bar underneath, screw holes side up and align the holes. You
should be able to feel when the points of the screws are in the holes of
the (4) Lower Cross Bar.
4.
Attach the (5) Side Legs to the (2,4) Cross Bars.
Put the (2, 3, 4) Cross Bars and Center Ratchet Post
Unit back leg side down/ratchet strip side up. Insert
the tongues from the (4) Lower Cross Bar in the slots
near the bottom edges of the (5) Side Legs. Make
sure that the legs are in front of the (2) Upper Cross
Bar and that the holes on the face, near the edges of
the (2) Upper Cross Bar and near the top of the (5)
Side Legs face each other.
5.
Get the (G) 2 Long Bolts, 2 of the (B)
Bolt Adapters, the (A) Hex Wrench and the slot
screwdriver. Put the (B) Bolt Adapters, slot out,
into the 2 large holes on the front of the (4) Lower
Cross Bar near the (5) Side Legs. Put your finger
1.
2.
3.
4.
4.
5.
5.
6.
6.
