optrel 1100.200, Assembly Instruction Manual

Page: 3 / 40

3
1
What you need:
1x 1x 1x
inside
Peel off the protection foil on both sides as shown
(inside and outside) - only the edges, not the whole foil
Right Left
!
Please make sure that the
bolt fits into the cutout
section
2
3
inside
outside
clear lens
!
Press together, use your thenar to get
the needed pressure or an item to get a
targeted hit.
4
!
As soon as you hear
the click, this section
is finished.
Right Left
Hints before we start
!
Make sure that none of the
parts is in the threaded area,
and all plates are guided by
the notch.
Correct
Wrong
5
Assembly of the right side
First of all, insert the pencil as shown. Then only remove the screw nut and the plate from the
headband, place the cover lens in between, hold the headband and the cover lens in one
hand and if possible stabilize the other side of the cover lens on a desk / table. Assemble the
plate and the screw nut.
!
Use a pencil
There is a hint how you get the plates rightly assembled (fitted on the bolt with the
notch and not in the threaded area), you only need a pencil - use it as shown in the
drawing below (green marked space on the headband).
Move the bolt to the
middle position
Put a pencil in between the gap to
ensure that the bolt will stay up to
assemble your plates.
Pencil
6
Assembly of the left side:
First of all, insert the pencil again on the left side. Place the headband on a desk / table and
only remove the screw nut and the plate (as shown). Hold the headband and the cover lens
with one hand and assemble the plates and screw nut as shown (use the additional plate
from the separate bag).
Face
shield
Hints
Right
side
Left
side
!
Make sure that the
Excenter bolt is flush with
the excenter knob (as shown
in the views).
!
Remember
table
click
inside
outside
Assembly instruction medmaxx
instruction video : scan QR-Code or following link:
https://medical.optrel.com/medmaxx/
Correct
Wrong
Pencil
headband
settings
1
2
3
get the headband perfectly fitted on your head.
Headband: Adjust the upper
adjustment band to your head
size. Press the ratchet button at
the back and turn it until the
headband fits snugly but
without pressure
Face distance: Loosen the
locking knobs to adjust the
distance between the face shield
and the face. Adjust both sides
equally and do not tilt them.
Then tighten the locking knobs
again.
Helmet inclination: can be
adjusted by turning the
eccentric knob.
Pencil
Screw nut
plate
desk / table
What you need: 1x
Screw nut
plate
Pencil
desk / table
fold the c
over lens
plate
!
Remember
Correct
Wrong
Cover lens
Cover lens
!
In case of an accidental disassemble of all parts, use the sequential arrangement below
What you need: 1x 1x
1.
2.
3.
5.
6.
7.
1.
2.
3.
5.
6.
4.
4.
Cover lens
Cover lens