IR Speed Dome User Manual
18
ADJUST BLANK POS
FOCUS SHIFT STATUS
SAVE: OPEN
QUIT: CLOSE
Figure 3-17
Set the Privacy Mask
(2)
You can see
ADJUST BLANK POS
message on the screen. Click the direction buttons to
adjust the position of the privacy mask to the designed scene.
(3)
Click
FOCUS +
button on the PTZ control panel, and you will see
ADJUST BLANK SIZE
message on the screen. Click the up/down buttons to increase/decrease the height of the
mask and click right/left buttons to increase/decrease the width of the mask. Click
IRIS+
button to save the settings and return to the previous menu and you can see the mask turn
to gray.
(4)
To modify the configured mask, click
IRIS+
button to enter the
SET BLANK
menu and click
IRIS+
button again to modify.
Note:
The tilt range for configuring the privacy masks is from 0 to 70°.
5.
Delete Blank.
Enter the
DELE BLANK
menu to delete the current privacy mask.
3.3
Restoring the Default Settings
Purpose:
You can reset all the dome settings to factory default parameters as shown in the table below.
Enter default dome settings menu:
MAIN MENUS > RESTORE DEFAUTLS
Click
IRIS+
to restore the dome settings to the default value as shown in the table below; or click
IRIS-
to exit.
Parameters
Default Value
Dome address
0
Baud rate
2400bps
120Ω matching
resistance
Off
Soft address
Off
Azimuth zero
Zero angle
Auto-focus
HAF
Zoom limit
Max Optical Zoom
Zoom speed
High
Low light limit
On
