IR Speed Dome User Manual
9
The value of gain indicates the amplification degree of the original image signal. You can set the
value from 0 to 15.
Exposure Compensation Function
:
You can set the
EXPOSURE COMP
value from 0 to 14. The value change can affect the exposure
effect, and the default value is 7.
White Balance
:
You can set
WHITE BALANCE
mode as
AUTO
,
INDOOR
,
OUTDOOR
,
SELFDEF
(self-defined),
ATW
(auto-tracking) and
HAUTO
(half-auto).
Image Flip
:
If you turn the
IMAGE FLIP
function on, the image will be flipped diagonally along its central axis,
shown as the mirror reflection of the image.
Note:
The image flip function is only supported by a certain camera model series.
Focus Limit
You can set
FOCUS LIMIT
as
30CM
,
1M
or
3M
to make sure that the speed dome focuses on the
target; when you set it as
1M
(default), the focus limit will automatically change according to
the lens zooming.
Init Lens
You can turn the
INIT LENS
on to trigger a spontaneous lens initiation to ensure the normal
operation
Noise Reduction
:
There are two options for noise reduction: ON or OFF.
HR Mode
Set
the HR MODE
as
ON
to adjust the resolution higher. Switch it
OFF
to disable the function,
which can avoid cross color of the image.
Contrast:
Adjust the image contrast on
CONTRAST
submenu to 0-7.
Saturation:
Adjust the image saturation on
SATURATION
submenu to 0-7.
3.2.3
Configuring the PTZ Parameters
You can configure the Park Time, Image Freeze, Dome Speed, etc. according to the steps in this
session. See Figure 3-7. Enter PTZ configuration menu:
MAIN MENUS > DOME SETUP > PTZ PARAMETER SET
