Optimus 42-4041, Owner'S Manual

Page: 34 / 60

34
Note: Press after you select Track 1
in Step 3 to use the drum pads. That
way, you can also start recording by
playing a drum pad.
This data is stored on Track 1 along with
the the notes you played:
• tone number
• rhythm number
• rhythm controller (
INTRO
,
NORMAL/
FILL-IN
, etc.) operations
• pitch bender operations
• pedal operations
• drum pad operations
See “Recording Multiple Tracks” on
Page 37 to record on the other five
tracks.
Notes:
• When you record on a track that
contains data, the new recording
replaces the previous recording.
• The touch response setting (on/off)
is not recorded. However, the
strength of the strike is recorded.
• Channel 1 mixer parameters are
automatically recorded to Track 1.
• The memory can store a total of
about 5,200 notes. If the remaining
memory is less than 100 notes, the
measure and beat numbers flash on
the display. When memory becomes
full, recording automatically stops
(and auto-accompaniment or rhythm
stops playing, if used).
• Memory contents are saved as long
as power is supplied to the key-
board. Unplugging the adapter with-
out batteries or with weak batteries
erases the memory. To prevent data
loss, connect an adapter before
replacing the batteries.
• Turning off the keyboard while
recording erases the contents of the
track you were recording.
• You can transfer memory contents
to another MIDI device. See “Dump-
ing/Importing Data” on Page 45.
PLAYING BACK FROM
MEMORY
1. Press
MEMORY
until Play No.
appears.
2. Within 5 seconds, use
+
or
–
(or
0
or
1
) to select a song number.
3. Within 5 seconds, press
START/
STOP
to play back the song you
selected. You can use
TEMPO
to
adjust the playback tempo.
4. Press
START/STOP
again to stop
playback.
Notes:
• You can use layer and/or split during
memory playback.
• You can change the rhythm during
playback.
• Pressing
START/STOP
during the
song restarts the song from the
beginning.
42-4041.fm Page 34 Tuesday, August 3, 1999 6:56 AM