Handling
OPTIMUM
M A S C H I N E N - G E R M A N Y
©
201
1
GB
Page 30
Metal belt saw
S150 G Vario
version 1.0
12 April 2011
Adjusting the speed of the saw belt with the potentiometer.
“Safety during operation“ on
page 14
Pull the saw arch on the handle down the workpiece until the workpiece is cut completely.
5.5
Switching off the metal belt saw
After sawing prozess release the press button. Make sure after sawing prozess that you do
not release the saw arm.
INFORMATION
For better handling of the saw arch is equipped with a return spring. When you release the saw
arch moving this back by the spring force in the top position
Actuate the push button "OFF".
Disconnect the electrical supply cable from the power supply during longer standstill of the
machine.
5.6
Adjusting the angular cut
To adjust angular cuts, place the locking
bar of the saw arch in the left-hand posi-
tion.
Turn the saw arch to the required cutting
position.
There is a scale for adjusting the angle on
the bearing support.
Lock the adjustment by clamping the
clamping lever.
Illustr.5-4: Clamping lever
5.7
Adjusting the saw belt guide
Change the position of the saw belt guide
depending on the size of the pieces to be
cut.
Loosen the setscrew.
Place the saw belt guide near the work
piece without affecting or hindering the
sawing process.
Illustr.5-5: Setscrew
Re-tighten the setscrew.
Clamping lever
Angular scale
Setscrew