OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.3.0 dated 2016-12-16
Page 33
Original operating instructions
MF2 Vario
GB
4.6.2 Automatic movement of the X-axis using the feed motor
The feed motor automatically moves the cross table along the X-axis.
Turn on the switch.
The service light comes on.
Adjust the feed speed using the speed regulator.
Move the direction lever to the direction in which you want the cross table to move.
When the lever is in the central position, the feed motor is halted.
Do not change the motor from L to R during the operation.Wait until it has come to a com-
plete halt.
The end stop switch and the two adjustable stops deactivate the automatic feed when the
preset position is reached.
Move the turning direction lever in the required direction.
Press the button for fast motion.
Once you release the button the machine will proceed at the preset speed.
WARNING!
When the feed motor is operating in fast motion, do not touch moving parts or rotating
parts.
Make sure there are no other people in the danger zone.
INFORMATION
The circuit is automatically disconnected if a current of 4 A circulates through the safety switch
for more than 10 seconds.
To reactivate it, press the safety switch for a moment.
The service light will come on again.
ATTENTION!
During manual operation the limit stops may collide with the end stop switch. This can
cause damage to the end stop switch.
4.7
Moving the cross table forward / back (Y-axis)
The cross table may be moved on the Y axis using the hand wheel, located at the front of
the machine.
Loosen the tightening lever.
Engage the handle by pushing it towards the clutch.
Turn the handle to the required position for the cross table.
Direction lever
Fast motion
Operation control light
Speed regulator
Safety switch
ON/OFF switch
