Optimum OptiGrind GH 10T, Operating Manual, Page: 49 / 74

Operation
Version 1.0.9 dated 2019-05-13 Page 49 Translation of the original instructions
GH 10T | GH 15T GB
GH10T_G
H15T_G
B_4.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
4 Operation
4.1 Safety
Commission the drill bit grinder only under the following conditions:

The drill bit grinder is in proper working order.

The drill bit grinder is used as intended.

The operating manual is followed.

All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the drill bit grinder immediately in the event
of any failure in operation and make sure that the drill bit grinder can not be started up acciden-
tally or without authorization.
Notify the person responsible immediately of any modification.

"Qualification of the staff“ on
page 40
4.2 Overview
4.3 Application range of coated grinding wheels
In addition to the classic abrasives corundum and silicon carbide and their further develop-
ments, e.g. zircon corundum, single crystal corundum and SOL-GEL corundum (SG corun-
dum), the group of CBN and diamond tools for precision machining is becoming increasingly
important. These superhard abrasives are natural and synthetic diamond grits "D" and synthetic
cubic boron nitride (CBN) grits "B".
CBN, the most expensive abrasive ever, is used exclusively for machining hardened steels
(HSS). With the diamond grinding wheel, all other materials, preferably tungsten carbides and
hard materials such as ceramics, glass, carbides, oxides, nitrides, CFRP, GFRP, PCBN, PCD
and diamond themselves, but also various plastics and even rubber can be economically proc-
essed.
Opening to
reduce the cross
cutting edge
Opening to regrind
spiral drills
Setting
point angle
ON/OFF switch
Setting screw
drill diameter
Opening
adjusting device
spiral drill