Safety
Version 2.1.1 - 2020-07-27
14
Translation of original instruction
B40 GSP
EN
B40G
SP_
GB_1
.f
m
1.9.4 Drill chuck protection
Adjust the protective equipment to the
correct height before you start working.
To do so, detach the clamping screw,
adjust the required height and re-tighten
the clamping screw.
A switch is integrated in the fixture of the
spindle protection which monitors that
the cover is closed.
INFORMATION
You cannot start the machine if the drill
chuck protection is not closed.
Img.1-5:
Drill chuck protection
1.9.5
Prohibition, warning and mandatory signs
INFORMATION
All warning signs must be legible. Check them regularly.
1.10
Safety check
Check the geared drill before each start-up or at least once per shift. Inform the person respon-
sible immediately of any damage, defect or change in operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation),
after every maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the geared drill
are legible (clean them, if necessary),
are complete (replace if necessary).
INFORMATION
Use the following table in order to organize the checks.
Integrated position
switch
Clamping screw
Drill chuck protection
General check
Equipment
Check
OK
Protective covers
Mounted, firmly bolted and not damaged
Signs,
Markings
Installed and legible
Date:
checked by (signature):