Version 1.0.4 - 2020-07-28
23
Translation of original instruction
MH22V
│
MH22VD
EN
MH
22
V_MH2
2
VD_G
B_3.
fm
Lock all clamping levers on the drilling-milling machine before you lift it.
Make sure that no add-on pieces or varnished parts are damaged due to the load suspen-
sion.
Take care with the centre of gravity of the machine.
3.5.1
Assembly
Organise the working area around the machine according to the local safety regulations. The
work area for operation, maintenance and repair must not be restrictive.
Follow the prescribed safety areas and escape routes according to VDE 0100 part 729 as
well as the environmental conditions for the operation of the machine.
The mains plug of the milling machine must be freely accessible.
The machine must only be installed and operated in a dry and well-ventilated place.
Avoid places near machines generating chips or dust.
The installation site must be free from vibrations also at a distance of presses, planing
machines, etc.
Provide sufficient space for the personnel preparing and operating the machine and trans-
porting the material.
Also make sure the machine is accessible for setting and maintenance works.
Check that the milling machine foundation is horizontal with a spirit level.
Check that the foundation has sufficient load-bearing capacity and rigidity.
ATTENTION!
Inadequate rigidity of the foundation will cause interaction of vibrations between the
milling machine and the foundation (resonant frequency of the components). If the
rigidity of the overall system is insufficient, critical speeds with annoying vibrations will
be reached very quickly and lead to bad milling results.
Fasten the machine substructure to the foundation.
Place the milling machine on the provided foundation.
WARNING!
The nature of the foundation and type of fixings used to secure the machine base to the
foundation must be capable of absorbing the loads caused by the milling machine. The
Centre of gravity
