USER MANUAL
HDMI MATRIX ROUTER : OHM-88
OHM-88 Manual
Page 19
3) Select
OK
to open the command window.
4) Type the command:
telnet 192.168.0.88
[Note] 192.168.0.88 is the default IP address of OHM88. Change IP address
as needed. (Refer to Chap. 2.6.6 and 2.8)
5) Press
ENTER
: “HDMI Matrix Router Connected” will be displayed.
6) Type serial command set. (Refer to Chap. 3.2)
Figure 2-6 Telnet connected
2.8 Ethernet Control
The OHM-88 can be controlled through the 10/100 base Ethernet port using either
graphic user interfaces or a command line interface.
The graphic user interfaces uses proprietary PC software.
The physical connection of OHM-88 can be made on the standard LAN or point to point
connection.
The command line interface uses a Telnet session to a private port.
To connect OHM-88 to Ethernet, specify a static IP address for OHM-88 (Refer to Chap.
2.6.6). The default IP address is 192.168.000.088.
2.8.1
SETTING THE IP ADDRESS of the PC
If the PC is connected to the OHM-88 through the 10/100 Base Ethernet port, a
static address should be configured on the PC:
1) Use Ethernet crossover cable (provided with OHM-88 system) for point
to point direct connection between PC or controller and OHM-88 or use
Ethernet strait cable to connect OHM-88 on LAN.
2) From the PC: select
Start
menu, select
Control Panel
.
3) In the
Control Panel
, select
Network Connections
.
In
Network Connections
, right click on
Local Area Connection
and select
Properties
tab.
