Installation
Important: Please use the installation procedure below. Improper, or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
Connect an AC/DC power adapter to the Rx module of M1-1000. Connect
another power adaptor to the Tx module, when your video controller or
graphic card doesn’t supply sufficient DC power through DVI connector.
Note:
In most cases, the Tx module could be run by the power +5V supplied
through a DVI pin (#14) from the graphic cards. After completing the
installation instruction, if the system doesn’t work properly, you have to
confirm the power capable to supply more than 200mA.
Step 3
Plug directly the Tx module of M1-1000 in the DVI receptacle of PC. Do
NOT
use any intermediate cable or adapter between them.
Figure 2 – Tx Module of M1-1000 Cable
1-3 Installation
Step 4
Plug the Rx module of M1-1000 in the DVI receptacle of display. Do
NOT
use
any intermediate cable or adapter between them.
Figure 3 – Rx Module of M1-1000 Cable
Step 5
Power on the PC and display.
Note:
You can replace any DVI cable or an M1-1000 into another M1-1000 by
following the
Step1
to
4
, while all powers of PC and display are ON.
Step 6
You can see processing of the system boot-up.
Note:
If cannot and having skipped the
Step 2
, you have to follow the
Step 2
instruction and then reset the M1-1000 system.
1-4 Installation (continued)
