Optical Systems Design OSD2010, Operator'S Manual

Page: 5 / 16

OPTICAL SYSTEMS DESIGN
DOC ID: 10117301
OSD2010 OPERATOR MANUAL
PAGE 5
1.2 TYPICAL CONFIGURATION
Figure 1 below indicates the typical set-up for an OSD2010 system.
FIGURE 1: OSD2010 TYPICAL CONFIGURATIONS
1.3 ECHNICAL SPECIFICATIONS
TABLE 1: TECHNICAL SPECIFICATIONS
SPECIFICATION PERFORMANCE
Optical Data Interface
Protocol transparent
Optical Data Rate
10Mbps to 10Gbps
Optical Port Connectors
SFP
SFP Options
Short haul, Long haul, CWDM, single fiber operation, etc.
Please consult OSD SFP datasheets or contact OSD
Alarms
SFP #1 Laser Fail
SFP #1 Loss of Received Optical Signal
SFP #2 Laser Fail
SFP #2 Loss of Received Optical Signal
Alarm Interface
4 Open drain outputs rated at 500mA @ 24V maximum;
Short to Ground when OK
Open Circuit when not OK or power off
Operating Temperature -20
°
C to +75
°
C
Relative Humidity 0 to 95% non-condensing
Power Requirements +10V to +36V
DC
or 22V to 28V
AC
@ 4VA
Power Connector 4 way 5.08mm terminal block
Alarm Connector
6 way 3.5mm terminal block
Indicators
2 x Laser OK/Not OK
2 x Received Optical Power OK/Not OK
Dimensions (mm) 60W x 94D x 26H (excluding flanges and connectors)
Weight
0.4kg
102201001